KVR21SE15S8/4
Transkript
KVR21SE15S8/4
Memory Module Specifications KVR21SE15S8/4 4GB 1Rx8 512M x 72-Bit PC4-2133 CL15 260-Pin ECC SODIMM DESCRIPTION This document describes ValueRAM's 512M x 72-bit (4GB) DDR4-2133 CL15 SDRAM (Synchronous DRAM), 1Rx8, ECC, memory module, based on nine 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR4-2133 timing of 15-15-15 at 1.2V. This 260-pin SODIMM uses gold contact fingers. The electrical and mechanical specifications are as follows: FEATURES • Power Supply: VDD=1.2V Typical SPECIFICATIONS CL(IDD) 15 cycles Row Cycle Time (tRCmin) 46.5ns(min.) Refresh to Active/Refresh Command Time (tRFCmin) 260ns(min.) Row Active Time (tRASmin) 33ns(min.) Maximum Operating Power TBD W* UL Rating 94 V - 0 Operating Temperature 0o C to +85o C Storage Temperature -55o C to +100o C *Power will vary depending on the SDRAM used. • VDDQ = 1.2V Typical • VPP - 2.5V Typical • VDDSPD=2.2V to 3.6V • Nominal and dynamic on-die termination (ODT) for data, strobe, and mask signals • Low-power auto self refresh (LPASR) • Data bus inversion (DBI) for data bus • On-die VREFDQ generation and calibration • Single-rank • On-board I2 serial presence-detect (SPD) EEPROM • 16 internal banks; 4 groups of 4 banks each • Fixed burst chop (BC) of 4 and burst length (BL) of 8 via the mode register set (MRS) • Selectable BC4 or BL8 on-the-fly (OTF) • Fly-by topology • Terminated control command and address bus • PCB: Height 1.18” (30.00mm) Continued >> kingston.com Document No. VALUERAM1474-001.A00 07/21/15 Page 1 continued HyperX MODULE DIMENSIONS 3.7 Max All measurements are in millimeters. 1.20 Side kingston.com Document No. VALUERAM1474-001.A00 Page 2
Podobné dokumenty
Spec Sheet PDF
Memory Module Specifications
HX424S14IB/4
4GB 512M x 64-Bit
DDR4-2400 CL14 260-Pin SODIMM
Spec Sheet PDF
DESCRIPTION
ValueRAM's KVR21R15S4/8HA is a 1G x 72-bit (8GB)
DDR4-2133 CL15 SDRAM (Synchronous DRAM) registered w/
parity, 1Rx4, ECC, memory module, based on eighteen 1G x
4-bit FBGA components. Th...
HX313C9F/4
eight 512M x 8-bit DDR3 FBGA components. This module has
been tested to run at DDR3-1333 at latency timing 9-9-9 at
1.5V. The JEDEC standard electrical and mechanical specifications are as follows: