Technicka dokumentace UMP-ALU

Technicka dokumentace UMP-ALU

apply to tensile load, transverse load and oblique tensile load under all angles pursuant to the general technical approval Z-21.2-1204. The provisions of this approval

Technicka dokumentace K1-PH.pd

2) The permitted load may be increased to 0.6 kN with unpunched solid bricks and/or unpunched solid sand-lime bricks (no gripping recess).

Technicka dokumentace UMP-ALU

apply to tensile load, transverse load and oblique tensile load under all angles pursuant to the general technical approval Z-21.2-1204. The provisions of this approval

Technicka dokumentace 2014

cutting devices or the correct application in theory and practice and the proper installation of our attachment elements.

Technicka dokumentace SLK-ALU

permitted load may be increased to 1.0 kN. 9) If the longitudinal girders of the rocks are at least min. 30 mm (old rocks) and the bore hole is created with a rotating motion, the permitted load ma...

Technische Doku EU Montageeleme

Quantile Fε% (also fractile) denotes a specific nominal value of a test series below or above which there is only one specific percentage ε of all measurement values. The specification of such a qu...

Zásobníky Flamco a příslušenství zásobníků

tlakových stupních.

Upevnění nástavbových dílů

CH

Technicka dokumentace ZyRillo

Transverse force PQ per M6 screw: 0.20 kN Transverse force PQ per M8 screw: 0.25 kN Transverse force PQ per M10 screw:0.30 kN

Technicka dokumentace DoRondo

Tensile force PZ per M6 screw: Tensile force PZ per M8 screw: Tensile force PZ per M10 screw:

Technicka dokumentace Quadroli